Skip to main content
SmallSkid SteersApply with Always Capital

More lift and hydraulic flow, still trailer-friendly

High-Capacity Stand-On Mini Loader

The upper end of the mini loader class. These machines trade a few inches of width for meaningfully more lift capacity and auxiliary hydraulic flow, which makes powered attachments like breakers, tree spades and larger augers realistic.

Approximate specifications

Research ranges only — not manufacturer specifications for a specific configuration.
SpecificationApproximate range
Rated operating capacityApprox. 900-1,400 lb
Operating weightApprox. 3,000-4,500 lb
WidthApprox. 42-50 in
HeightApprox. 52-60 in
Engine powerApprox. 25-40 hp
Auxiliary hydraulic flowApprox. 12-18 gpm

Where this class fits

Best for

  • Tree care and cleanup
  • Utility support work
  • Heavier powered attachments
  • Small demolition

Watch-outs

  • May no longer fit through the narrowest gates — measure before assuming access.
  • Attachment package can approach the cost of the carrier.

Pricing and rental guidance

Buying

New pricing commonly lands above the narrow mini class and overlaps entry-level compact loaders. Compare total package cost, not base machine cost.

How pricing works

Renting

Rents at a modest premium over narrow mini loaders and is widely stocked in metro yards.

Rental guidance by market

Sponsored / referral opportunity

Dealer, rental and financing options

Where an approved commercial placement is configured, it will be clearly labeled. Editorial specifications and guidance remain separate from compensation.

No partner-specific destination is active for this placement.

Common attachments for this class

  • Grapple Bucket

    Grabs irregular material — brush, limbs, demolition debris, rock — that a plain bucket cannot hold.

    Requires auxiliary hydraulics. Check the weight of the attachment itself against the machine's capacity.

  • Auger

    Drills post holes and footing holes far faster than hand digging, with bit sizes matched to the job.

    Requires auxiliary hydraulics. Flow rating must match the drive head; rocky soil needs rock-specific teeth.

  • Hydraulic Breaker

    Breaks concrete, asphalt and rock in tight areas where a full-size breaker cannot reach.

    Requires correct hydraulic flow and pressure. Undersized carriers reduce productivity and stress the machine.

  • General Purpose Bucket

    The default tool on nearly every machine: moving soil, gravel, mulch and spoil, plus rough backfill and grading.

    No auxiliary hydraulics required. Match bucket width to machine width so you are not dragging spoil off-line.

  • Trencher

    Cuts consistent-depth trenches for irrigation, drainage, low-voltage and utility runs.

    Requires auxiliary hydraulics and adequate flow. Chain and tooth selection should match soil type.

Full attachment guide

Frequently cross-shopped with Vermeer

Vermeer's mini skid steers are frequently paired with the brand's stump cutters, chippers and tree care equipment. Crews that already run Vermeer gear benefit from consistent service relationships and attachment compatibility.

Read the Vermeer overview

Apply for equipment financing from $10,000 to $5 million

The application is on Always Capital, not on this site. Always Capital decides approval and terms. Small Skid Steers is not the lender.

Other size classes